Total
934 CVE
| CVE | Vendors | Products | Updated | CVSS v2 | CVSS v3 |
|---|---|---|---|---|---|
| CVE-2026-4111 | 2026-09-01 | N/A | 7.5 HIGH | ||
| A flaw was identified in the RAR5 archive decompression logic of the libarchive library, specifically within the archive_read_data() processing path. When a specially crafted RAR5 archive is processed, the decompression routine may enter a state where internal logic prevents forward progress. This condition results in an infinite loop that continuously consumes CPU resources. Because the archive passes checksum validation and appears structurally valid, affected applications cannot detect the issue before processing. This can allow attackers to cause persistent denial-of-service conditions in services that automatically process archives. | |||||
| CVE-2026-10683 | 1 Zephyrproject | 1 Zephyr | 2026-09-01 | N/A | 2.4 LOW |
| In the Synopsys DesignWare I2C driver (drivers/i2c/i2c_dw.c) operating in target/slave mode, the rx_full interrupt handler gates the write_requested() callback on dw->state != CMD_SEND, and dw->state is only reset to READY on a STOP interrupt. The START_DET interrupt, whose handler in i2c_dw_slave_read_clear_intr_bits() would reset the state on every (re)START, was never added to the enabled interrupt mask in i2c_dw_slave_register(), so that recovery path was dead code. As a result, if the STOP interrupt is lost (bus glitch/reset, or a concurrent master driving STOP) or the bus master issues a legal WRITE-repeated-START-WRITE sequence with the same direction, the driver remains in CMD_SEND permanently and never invokes write_requested() again for the life of the target. An I2C master on the same physical bus can deliberately trigger this, causing the I2C target function to malfunction for all subsequent write transactions and desynchronizing consumer framing state (e.g. MCTP-over-I2C), a recoverable-by-reset denial of service of the target peripheral. The fix unmasks START_DET so the state is reset at every bus (re)START. Impact is availability-only over a local board-level bus; no memory corruption results in the in-tree consumer, whose per-byte buffer write is independently bounds-checked. | |||||
| CVE-2026-82605 | 2026-08-31 | 5.0 MEDIUM | 4.3 MEDIUM | ||
| A vulnerability has been found in BareBones BBEdit up to 15.5.5. The affected element is an unknown function of the component Lasso Language Tokenizer. Such manipulation leads to infinite loop. The attack can be executed remotely. Upgrading to version 16.0 is sufficient to fix this issue. The affected component should be upgraded. | |||||
| CVE-2026-13002 | 1 Redhat | 2 Enterprise Linux, Openshift Container Platform | 2026-08-31 | N/A | 4.4 MEDIUM |
| A flow has been identified into dnssec.c library, causing an infinite loop to dnsmasq service. An attacker who controls any DNSSEC-signed zone can hang the dnsmasq process with a single crafted response, killing all DNS resolution for its clients. | |||||
| CVE-2025-10903 | 1 Gitlab | 1 Gitlab | 2026-08-31 | N/A | 6.5 MEDIUM |
| GitLab has remediated an issue in GitLab EE affecting all versions from 11.10 before 19.1.7, 19.2 before 19.2.5, and 19.3 before 19.3.1 that, under certain conditions, an authenticated user could have caused denial of service, due to an unbounded loop triggered by specially crafted input in the SCIM user provisioning feature. | |||||
| CVE-2026-68762 | 2026-08-28 | N/A | 5.9 MEDIUM | ||
| In JetBrains Ktor before 3.4.1 potential DoS attack via WebSocket decompression was possible | |||||
| CVE-2026-78250 | 2026-08-27 | 4.0 MEDIUM | 4.3 MEDIUM | ||
| A vulnerability was identified in bytebot-ai bytebot 0.0.1. The affected element is an unknown function of the component Agent Execution Workflow. Such manipulation leads to infinite loop. The attack may be performed from remote. The exploit is publicly available and might be used. This vulnerability only affects products that are no longer supported by the maintainer. | |||||
| CVE-2026-67214 | 1 Nanoid Project | 1 Nanoid | 2026-08-26 | N/A | 5.9 MEDIUM |
| nanoid (Nano ID) before 3.3.16 and 5.1.16 contains an infinite loop in the customAlphabet and nanoid functions of its non-secure module (nanoid/non-secure). When these functions are given a negative size, the loop counter is decremented from a negative value and never reaches its termination condition, spinning indefinitely and hanging the calling thread. An application that passes an unvalidated, attacker-controlled negative size to these functions is exposed to a denial-of-service condition. | |||||
| CVE-2026-12629 | 2026-08-26 | N/A | 4.6 MEDIUM | ||
| The ARM PL011 UART driver in drivers/serial/uart_pl011.c fails to acknowledge receive error interrupts. On the PL011, the framing, parity, break, and overrun error interrupts (PL011_IMSC_ERROR_MASK) are cleared only by writing the interrupt-clear register UARTICR; reading the data register clears the RX interrupt and the per-byte RSR status but not the error interrupt status in MIS. The interrupt service routine pl011_isr() acknowledged only the CTS modem-status interrupt and never wrote icr for the error bits, so an asserted error interrupt remains pending after the ISR returns. When an application enables error-interrupt reporting via the public uart_irq_err_enable() API, an attacker who controls the serial peer can deterministically assert these error bits by injecting line errors on the RX line — a baud/stop-bit mismatch or mid-character break (framing/break error), a flipped parity bit (parity error), or FIFO flooding (overrun error). Because the error interrupt is never cleared, the interrupt line stays asserted and the CPU re-enters pl011_isr() immediately and indefinitely, producing an interrupt-storm livelock from which the core makes no forward progress. The impact is an availability-only denial of service (permanent hang), reachable from an external or removable UART peer. Exploitation is gated by configuration: the error interrupt is off by default and no in-tree subsystem enables it, so only applications that explicitly call uart_irq_err_enable() on a PL011-based, interrupt-driven port are affected. The fix makes pl011_isr() acknowledge the pending error bits via uart->icr, breaking the loop, and additionally clears the latched RSR status in pl011_err_check(). | |||||
| CVE-2026-12236 | 2026-08-26 | N/A | 6.5 MEDIUM | ||
| The Bluetooth host GATT client function parse_read_std_char_desc() in subsys/bluetooth/host/gatt.c parses an ATT Read By Type Response received from a remote GATT server during BT_GATT_DISCOVER_STD_CHAR_DESC discovery. The per-entry stride rsp->len is taken directly from the peer's PDU, and the parse loop both tests its exit condition (length >= rsp->len) and advances (length -= rsp->len, pdu += rsp->len) using that value. The minimum value of rsp->len was never validated before the loop. A malicious or malfunctioning peer can reply with rsp->len = 0. Because length is unsigned and never decreases, the loop condition stays true forever and the read pointer never advances; as long as the body is at least a few bytes with a non-zero handle and a matching descriptor UUID, the host repeatedly re-parses the same bytes and invokes the discovery callback, never terminating. This hangs the Bluetooth host processing thread (CWE-835, loop with unreachable exit condition). The condition is reachable by any connected peer once the local device initiates standard-descriptor-value discovery; GATT discovery does not require bonding or encryption, so an unauthenticated adjacent attacker that the device connects to can trigger it. The impact is denial of service of the Bluetooth subsystem (and likely a watchdog reset on constrained targets); there is no memory disclosure or corruption. The fix adds a rsp->len < sizeof(struct bt_att_data) check before the loop, rejecting under-length responses so the stride is always non-zero and the loop terminates. The sibling parsers parse_include() and parse_characteristic() already validated rsp->len and are unaffected. | |||||
| CVE-2026-18726 | 1 Redhat | 1 Enterprise Linux | 2026-08-25 | N/A | 6.5 MEDIUM |
| A flaw was found in open-iscsi. This vulnerability allows a remote attacker on the same local network segment to cause a Denial of Service (DoS) in the iscsiuio daemon. By sending a specially crafted Internet Control Message Protocol version 6 (ICMPv6) Router Advertisement with a zero-length option, the attacker can trigger an infinite loop. This leads to sustained CPU usage, rendering the daemon unresponsive and impacting system availability. A secondary risk of out-of-bounds reads exists with a short IPv6 payload, though no memory corruption or data exposure has been confirmed. | |||||
| CVE-2020-13935 | 7 Apache, Canonical, Debian and 4 more | 18 Tomcat, Ubuntu Linux, Debian Linux and 15 more | 2026-08-25 | 5.0 MEDIUM | 7.5 HIGH |
| The payload length in a WebSocket frame was not correctly validated in Apache Tomcat 10.0.0-M1 to 10.0.0-M6, 9.0.0.M1 to 9.0.36, 8.5.0 to 8.5.56 and 7.0.27 to 7.0.104. Invalid payload lengths could trigger an infinite loop. Multiple requests with invalid payload lengths could lead to a denial of service. | |||||
| CVE-2022-23437 | 3 Apache, Netapp, Oracle | 29 Xerces-j, Active Iq Unified Manager, Agile Engineering Data Management and 26 more | 2026-08-25 | 7.1 HIGH | 6.5 MEDIUM |
| There's a vulnerability within the Apache Xerces Java (XercesJ) XML parser when handling specially crafted XML document payloads. This causes, the XercesJ XML parser to wait in an infinite loop, which may sometimes consume system resources for prolonged duration. This vulnerability is present within XercesJ version 2.12.1 and the previous versions. | |||||
| CVE-2026-45271 | 2026-08-25 | N/A | 5.5 MEDIUM | ||
| Picotls is a TLS protocol library that allows users select different crypto backends based on their use case. Picotls implements its own ASN.1 validation helper, which is used by the minicrypto backend while parsing local PKCS#8 private keys. Prior to commit c14231d801407640bc42c2dcf92783409ea6a7c7, the validator recursively descends into constructed ASN.1 elements without enforcing a maximum nesting depth. If an application loads an attacker-supplied private-key file through ptls_minicrypto_load_private_key(), or otherwise calls the public ASN.1 validation API on untrusted DER, a crafted deeply nested ASN.1 structure can exhaust the process stack and crash the application. Note that the libcrypto (OpenSSL) backend does not use the ASN.1 validation helper of picotls, and therefore is immune to this vulnerability. The vulnerability has been addressed in commit c14231d801407640bc42c2dcf92783409ea6a7c7. | |||||
| CVE-2026-4890 | 2026-08-25 | N/A | 7.5 HIGH | ||
| A Denial of Service (DoS) vulnerability in the DNSSEC validation of dnsmasq allows remote attackers to cause a denial of service via a crafted DNS packet. | |||||
| CVE-2026-54623 | 2026-08-20 | N/A | 7.1 HIGH | ||
| django CMS is an easy-to-use and developer-friendly enterprise content management system powered by Django. Prior to 5.0.8, the move_plugin endpoint in cms/admin/placeholderadmin.py accepts an attacker-controlled plugin_parent value without rejecting a plugin’s own identifier or a descendant identifier. A staff user with plugin-change permission under CMS_PERMISSION can create a parent_id cycle in the plugin tree. The _get_descendants_cte and _get_ancestors_cte queries in cms/models/pluginmodel.py have no cycle guard, so get_descendants() and later rendering, copy, or delete operations can recurse indefinitely or reach a database recursion limit, corrupting the tree and consuming request workers. This issue is fixed in versions 5.0.8. | |||||
| CVE-2026-20054 | 1 Cisco | 4 Cyber Vision, Secure Firewall Threat Defense, Snort and 1 more | 2026-08-20 | N/A | 5.8 MEDIUM |
| Multiple Cisco products are affected by a vulnerability in the Snort 3 VBA feature that could allow an unauthenticated, remote attacker to cause the Snort 3 Detection Engine to crash. This vulnerability is due to improper error checking when decompressing VBA data. An attacker could exploit this vulnerability by sending crafted VBA data to the Snort 3 Detection Engine on the targeted device. A successful exploit could allow the attacker to cause the Snort 3 Detection Engine to enter an infinite loop, causing a DoS condition. | |||||
| CVE-2026-45820 | 1 101arrowz | 1 Fflate | 2026-08-19 | N/A | 7.5 HIGH |
| fflate through 0.8.2 is vulnerable to denial of service via an infinite loop in unzipSync(). A crafted ZIP archive with a central directory entry declaring compressed_size=0xFFFFFFFF (ZIP64 sentinel) but missing the required ZIP64 extra field tag 0x0001 causes z64e() to loop indefinitely due to out-of-bounds reads returning undefined, which coerces to 0, keeping the loop condition permanently true. | |||||
| CVE-2026-64611 | 2026-08-19 | N/A | 7.5 HIGH | ||
| A flaw was found in libcupsfilters. The cfIEEE1284NormalizeMakeModel() function enters an infinite loop when processing a printer-advertised IEEE-1284 device ID with an empty model field, causing sustained CPU consumption. A network-adjacent attacker could exploit this by broadcasting a specially crafted printer advertisement, leading to denial of service. | |||||
| CVE-2026-59849 | 2 Libssh, Redhat | 3 Libssh, Enterprise Linux, Hardened Images | 2026-08-19 | N/A | 3.1 LOW |
| A flaw was found in libssh. Logic errors in automatic certificate-based public key authentication can cause libssh clients to loop indefinitely when configured certificates are missing or repeatedly rejected by a server, leading to denial of service. | |||||